TR Register Forum
https://forum.tr-register.com.au/

Outer wing Fixings
https://forum.tr-register.com.au/viewtopic.php?f=5&t=315
Page 1 of 1

Author:  Peter W [ Tue Feb 07, 2017 5:24 pm ]
Post subject:  Outer wing Fixings

Hi all

A small question which comes as a result of getting our TR3A as a series of unconnected panels and a series of bits piled into tea chests!

Dumb question # 2b.

There are, it seems, two different sets of captive nuts ( and set screws) in boxes to attach the wings front and back.
From the Stanpart parts catalogue I have the front set screws (HU.0705) as 1/4" U.N.F. x 5/8" and the rear as HU.0706 P (pointed) 1/4" UNF x 3/4"

However if you look at the attached photo which shows my confused scrawlings from the weekend,the square nut that seems to fit the rear cages, which are bigger, are 1/2" across the flat and take a 5/16" Screw. There are also some random 3/8, 16 thread arrangements which seem to not fit the cage.
Can anyone throw any light onto the correct arrangement?
The panels are in fairly good shape as are most of the cages.
I have acquired square nuts and cages from Moss but they are all the smaller (front?) set up and won't work on the rear guards.

Clues please???

Peter W :?:

Attachments:
wing fixings.jpg
wing fixings.jpg [ 44.72 KiB | Viewed 1518 times ]

Author:  Peter W [ Fri Feb 10, 2017 10:35 pm ]
Post subject:  Re: Outer wing Fixings

thanks vivdownunder

great information... makes the jigsaw puzzle a little less confusing

Peter W

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/