TR Register Forum
https://forum.tr-register.com.au/

girling diff bearings
https://forum.tr-register.com.au/viewtopic.php?f=5&t=403
Page 1 of 1

Author:  Johnjohnson [ Sat Nov 11, 2017 3:31 pm ]
Post subject:  girling diff bearings

Hi All
Does anyone know all the bearing and seal numbers needed to rebuild a Girling diff?
I have tried looking at the moss and co sites but they don't give me ALL the numbers. jj

Author:  TR1954 [ Sat Nov 11, 2017 9:25 pm ]
Post subject:  Re: girling diff bearings

Can't help Johnno, but if anyone has a Girling rear end they don't need I will pay handsomely to acquire it.

Author:  Trolleybus [ Mon Nov 13, 2017 9:34 am ]
Post subject:  Re: girling diff bearings

Hello John,
Last time I replaced the seals in Trolleybus I took the old seal to a company called BJ Bearings. The helpful staff measured it and supplied one with the correct OD and ID however it was half the width, so I fitted two each side. This meant that the seal did not run on the grove made by the original seal but on either side. I have done the same thing with bearings that is taken it to the store and had it measured and matched and I suspect I got a better quality product at a better price than using a company like Moss.

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/